The problem of water leakage in household water purifiers is a headache for consumers, and it is not a leak or wet floor or a bad floor. If the water leaks downstairs, it may cause tension in the neighborhood. So, what is the cause of water leakage from household water purifiers? How to avoid it?
First, the reasons for water leakage from household water purifiers are summarized as follows:
1, the quality of the household water purifier itself
Including the quality of household water purifier parts, the fineness of household water purifier assembly, pressure test and inspection quality. Household water purifier parts are mainly joints (connectors). According to consumers, many household water purifiers that leak water are joints that are not quality, not resistant to pressure, not durable, and are not resistant to water hammer. The PE pipe used for connection is of poor quality, the concentricity is not good enough, the pipe wall thickness is not uniform, and the pressure is not.
2, the water purifier is not properly installed
Another reason for water leakage from household water purifiers may also be that the production workers are not properly connected to the various components inside the household water purifier or are not connected stably.
3, the joint is not tight
There is also a joint that does not connect the machine and the water pipe during the installation of the water purifier.
4. The material quality of the outer cylinder is too bad.
The appearance of the household water purifier is too poor in material quality and can cause water leakage.
Second, the solution to the water purifier leakage:
(1) Water leakage at the water outlet:
Due to the wear of the shaft gasket in the faucet. Use pliers to loosen and remove the gland, remove the shaft gasket with a clip, and replace it with a new one.
(2) Leakage in the lower part of the faucet:
That is caused by the wear of the triangular seal inside the gland. You can loosen the screw to remove the hoe, then loosen the gland, then remove the gland inside the triangle seal shop and replace it with a new one.
(3) Leakage at the joint joint:
Roughly the cap nut is loose, you can retighten the cap nut or replace it with a new U-ring.
(4) The situation of less water:
It may be that a water leak occurs because the water stop disk of the single gun faucet is stuck with the sand stone. This phenomenon is still to find a professional repairer to disassemble the faucet, but if the rubber pad is damaged, it must be replaced.
Water purifiers are now almost a must-have for family life. However, there are also many users who tell us how to do when the water purifier is used for a period of time and the water is slow. What should we do?
In order to fully filter the secondary pollutants in the tap water, the water purifier does need a "patience" and "serious" when filtering the water, so the effluent is not so large compared to the usual tap water. However, if the water situation is very small, then don't worry, we can find the reasons from the following points:
Cleaning/replacement filter
In general, when the water flow becomes small, it is common that the filter element is cleaned. This is because when the filter element filters the tap water, it will block the visible sediment, rust, organic impurities and other contaminants on the surface of the filter element. If it has not been cleaned/replaced for a long time, it may cause more pollutants to pile up. Thereby affecting the filtering speed.
Air exhaust
If you have a problem with small water, you can check if there is any air in the machine. If there is air in, you can try to drain the air.
Not enough water pressure
If there is no air problem, it may be because the water pressure is not enough, resulting in too little water. This is because when the water pressure is 2Bar, the standard water output is 1.9 liters/min. If the water pressure is lower than the standard, the water output will be slowed down. This phenomenon is common in high-floor residents, if it is affected by water pressure problems. For water, consider installing a pressure pump to increase the water pressure.
Copper Tube Terminals Without Checking Hole
Our company specializes in the production and sales of all kinds of terminals, copper terminals, nose wire ears, cold pressed terminals, copper joints, but also according to customer requirements for customization and production, our raw materials are produced and sold by ourselves, we have their own raw materials processing plant, high purity T2 copper, quality and quantity, come to me to order it!
Copper Tube Terminals Without Checking Hole,Cable Lugs Insulating Crimp Terminal,Cable Connector Tinned Copper Ring Terminal,Tubular Cable Lugs Crimp Terminal
Taixing Longyi Terminals Co.,Ltd. , https://www.lycopperlugs.com